This post is part of a meta-series. Click here for a list of all posts in this series.
Satisfied with my revised model and with scale issues now addressed, I decided to make one more prototype before printing out a high-resolution paper model that will go on to form the basis of my helmet mold. This one would be very low resolution, its only purpose to validate that it was big enough for my head and that my proportions were vaguely correct.
As it turned out, this actually went a little too small, due in part to compensating for the size correction in the 3D model, but not the printout. Fortunately, it means the next round should be bang-on. I also acquired some fiberglass mat and resin with which to reinforce the paper model prior to slathering it with Bondo, which is heavy. I don’t want the paper to deform under the weight, so the fiberglass-and-resin step aims to give it enough rigidity to prevent that. The original large prototype is shiny in these pictures because it’s been given an initial outer coat of resin. The fiberglass will go inside for structural strength.
I, uh, also couldn’t resist checking the sizing prototype’s fit…